4x A4988 Stepper Motor Driver with Heat Sink + CNC Shield Expansion Board for Arduino V3 Engraver New

     CNC Shield Board:

     Latest CNC Shield Version 3.0 for Arduino.
     GRBL 0.9 compatible. (Open source firmware that runs on an UNO for Arduino that turns G-code commands into stepper signals)
      PWM Spindle and direction pins
      4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a  full 4th axis with custom firmware using pins D12 and D13)
      2 x End stops for each axis (6 in total)
      Coolant enable
      Uses removable A4988 or DRV8825 compatible stepper drivers
      Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to  1/32 micro-stepping )
      Compact design.
      Stepper Motors can be connected with 4 pin molex connectors or soldered in place.
      Runs on 12-36V DC. (At the moment only the DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)
      Please note that this is an unassembled kit and Basic soldering skills are needed.


    A4988 Stepper Motor Driver:

    A4988 Stepper Motor Driver Board is a breakout board for Allegro’s A4988 DMOS Micro stepping Driver with Translator and Overcurrent Protection; please read the A4988 datasheet carefully before using this product.
    Low RDS (On) Output
    Automatic current decay mode  detection / selection
    Mix with slow current decay modes
    Synchronous rectification for low power dissipation
    Internal UVLO
    Crossover-current protection
    3.3 and 5 V compatible logic supply
    Thermal shutdown circuitry
    Ground fault protection
    Load short-circuit protection
    Five selectable step modes: full,  1/2, 1/4, 1/8 and 1/16
    Warning: Connecting or disconnecting a stepper motor while the driver is powered can destroy the driver. (More generally, rewiring anything while it is powered is asking for trouble).


Package Includes:
1 x CNC Shield Board
4 x A4988 Stepper Motor Driver
4 x Heat Sink